The crusher plant users will often have a question in their mind that which material is a good choice and how long the product will be useful? What are all the difference between the Mn18 and Mn13 and also they will even have a question that whether the Mn18 will be better than M13 or not and so on.
There are many casting workers have undergone a deep experiment and have shared their experience about the factors that have an effect on the crusher wear parts span life. The crusher part that is mentioned here is just all about the casting wear parts such as chrome casting parts and manganese casting parts such as roll mill liner, cone liner, jaw plate, and so on.
How crusher part material choice will have its effect on Shredder Parts the crusher wear parts span life?
Most of the crusher parts except the blow bar are all manufactured by manganese steel where the blow bar material is rich in manganese. There are 3 trademarks in manganese steel and they are as follows Mn22, Mn18, and Mn14. If the high manganese steel gets a very impact or the crushing stress, then its surface will get hard very quickly and also at the same time, the body of it will still have a very good toughness so that if the surface gets harden with more adequate then it will be very good for wearing.
High manganese steel will have the low hardness that is HB 170 to 230 so that when there is an extreme limit for the uncured wear, the surface will not be sufficiently hardened where the wearable will not promise. And now you have the question that which material is the good choice based on the products that you crushed. For the manganese casting foundry, abandoned manganese steel will reach the Mn content elements but however, if there is a need of 18 percent content or even more, the electrolysis manganese is the best and only choice.
So for everything, the basic thing is that you have to choosing the best material for making the final product as without the best material the final product will not have the best quality and will not last long and get help from experts before going to buy any crusher wear parts.
How heat treatment will have its effect on the crusher wear parts span life?
The most important and main step in casting is a heat treatment which will have the direct effect on the product quality. Before you are doing the heat treatment, the casting surface should be very clear and also there should be strict control on the time from the casting furnace to the water pool along with that there should be a decrease in the content of the carbon on the product’s surface and also, there is a need for caring about the temperature of the water pool where the standard of the European for the water pool temperature should be lower than the 20 degree Celsius.
How printing and machining will have its effect on the crusher wear parts span life?
After the heat treatment, the castings will be sent to the shop where there will be a machining work will take place for machining and here they will correct the size of the casting and made it suit for the crusher plant. And as the last step, the casting with correct and suitable size will have some printings process which the last but not the least step. This painting process not only makes the castings beautiful and also the printing process protects the castings from oxidation.
Through this printing process only the casting looks beautiful and many customers choose the castings not only good with high quality but by its beauty. So that printing process will be done by the specialist to make it more attractive and also at the same time the machining is the process that makes the castings to have the correct and opt size. The castings that are in the right size with good and awesome printing will be a great hit among the crusher plant users, new traders and also the regular traders.
